Once hooked, a small trout can be easily retrieved "on the reel" or by simply pulling in the fly line with the reel hand while pinching the line between the rod handle and the index finger of the rod hand. It is important to keep the rod tip high, allowing the bend of the rod to absorb the force of the fish's struggles against the line. Larger trout will often take line in powerful runs before they can be landed. Unlike spin fishing where the line is already on the reel, playing a large fish with fly line and a fly reel can present a special challenge. Usually, when a fish is hooked, there will be extra fly line coiled between the reel and the index finger of the rod hand. The challenge is to reel up the loose fly line onto the reel without breaking off a large fish (or getting the line wrapped up around the rod handle, one's foot, a stick or anything else in the way!). Once the extra line is on the reel, an angler can use the reel's drag system to tire the fish.
Main article: Catch and release
Releasing wild trout helps to preserve the quality of a fishery. Trout are very delicate and should be handled carefully to ensure the animal's survival. Trout should be handled with wet hands to minimize harm to the animal. Small trout caught on a barbless hook can be released simply by grasping the fly and turning it so that the hook point is pointed downward. It is important to minimize the handling of any fish that is to be released. Large fish can be grasped gently in a wet hand and quickly inverted so that the fish is upside down. Trout in this position stop struggling. Forceps can then be used to back out the hook. Once the hook has been removed, place the trout in the water and support it until it regains sufficient strength to swim away. If the fight was quite long, it may take some time to revive a weakened fish. If the trout is bleeding then it should not be released.
Saltwater fly fishing is done with heavier tackle and typically uses wet flies resembling baitfish. However, saltwater fish can also be caught with "poppers," a surface lure similar to those used for freshwater bass fishing, though much larger. Saltwater species sought and caught with fly tackle include: bonefish, tuna, dorado (mahi-mahi), sailfish, tarpon, striped bass, salmon and marlin. Offshore saltwater species are usually attracted to the fly by "chumming" with small baitfish, or "teasing" the fish to the boat by trolling a large hookless lure (Billfish are most often caught using this latter method).
Saltwater species when hooked cannot be "palmed" with the hand on the reel. Instead, a good saltwater reel must have a powerful drag system. Furthermore, saltwater reels must be larger, heavier, and corrosion-resistant - a typical high-quality saltwater reel costs 500.00 USD or more.
Saltwater fishing may be done from shore, such as wading for bonefish or striped bass, or offshore for larger species from boats of varying size.
Hooks for saltwater flies must also be extremely durable and corrosion resistant. Most saltwater hooks are made of stainless steel, but the strongest (though less corrosion resistant) hooks are of high-carbon steel. Typically, these hooks vary from size #8 to #10 for bonefish and smaller nearshore species, to size #3/0 to #5/0 for the larger offshore species.
Artificial flies, constructed of furs, feathers and threads bound on a hook were created by anglers to imitate fish prey. The first known mention of an artificial fly was in 200AD in Macedonia. Most early examples of artificial flies imitated common aquatic insects and baitfish. Today, artificial flies are tied with a wide variety of natural and synthetic materials to represent all manner of potential freshwater and saltwater fish prey to include aquatic and terrestrial insects, crustaceans, worms, baitfish, vegetation, flesh, spawn, small reptiles, amphibians, mammals and birds, etc.
Fly rods normally vary between 2 m (6 feet) and 4 m (13 feet) in length. Fly rods and lines are designated as to their "weight", typically written as Nwt where 'N' is the number (e.g. 8wt, 9wt, 10wt).
Rods are matched to the line according to weight. The rod's manufacturer will mark on the rod the fly line weights for which a rod has been designed. One-weight (1wt) rods and lines are the lightest; the weight designations increase up to the heaviest readily available rods and lines at 16-weight (16wt).[2] In general, 1wt through 2wt would be in the class used for small trout, and panfish, 3wt and 4wt are popular for small-stream fishing, 5wt is often considered the all-around rod for trout, 6wt and 7wt are used on large rivers and for fishing with streamers, 8wt to 9wt rods and lines might be used for steelhead or salmon in medium rivers, as well as for bass fishing with large flies and as lightweight salt water use, and 16wt rods and lines would be used for pursuing large salt water gamefish under conditions of high wind or surf.
The species pursued, under which conditions, will largely determine the weight of rod selected. Next, it is important to match the line to the weight of the rod. Using too heavy a line on too light on a rod, or vice versa, will dramatically affect casting performance. It may also permanently warp the rod blank. As a rule of thumb, you can safely go one line weight more or less (i.e. using an 8wt or 10wt line on a 9wt rod). There are also rods stamped with a range of weights. For example, a rod may be rated 7-8wt. This indicates the rod is designed for either a 7 or 8 weight fly line. There are also some rods rated for wider ranges (e.g. 8-9-10wt). The drawback to multi-rated rods is that compromises in flexibility or action are made in order to accommodate a wider range of line weights. For example, a rod rated for 8-9 weight line will be slightly stiffer than a straight 8wt but slightly softer than a straight 9wt rod.
Saltwater fly rods are built to handle powerful fish and to cast large, bulky flies over longer distances or into strong winds. Saltwater fly rods are normally fitted with heavier, corrosion-resistant fittings. The reel seat may also be equipped with a short extension often called a "fighting butt". Rods for saltwater fishing fall into the 8 to 15 weight class, with 12-weight being typical for most larger species like tuna, dorado (mahi-mahi) and wahoo (ono).
The earliest fly rods were made from greenheart, a tropical wood, and later bamboo originating in the Tonkin area of Guangdong Province in China. The mystical appeal of handmade split-cane rods has endured despite the emergence over the last 50 years of cheaper rod-making materials that offer more durability and performance: fiberglass and graphite.
Split-cane bamboo fly rods combine sport, history and art. It may take well over 100 hours for an experienced rod builder to select and split the raw cane and then to cure, flame, plane, file, taper, glue, wrap and finish each rod. Quality rods made by famous rod makers may sell for prices well beyond US$2,000; a new rod from a competent, contemporary (though not famous) builder may sell for nearly as much. These rods offer grace, form, and, with their solid mass, surprising strength. Bamboo rods vary in action from slow to fast depending on the taper of the rod. In competent hands, they provide the pinnacle in performance.
Today, fly rods are mainly made from carbon fiber/graphite with cork or, less frequently, hypalon being favored for the grip. Such rods generally offer greater stiffness than bamboo, are much more consistent and less expensive to manufacture, and require less maintenance. Fiberglass was popular for rods constructed in the years following World War II and was the "material of choice" for many years. However, by the late 1980s, carbon/graphite composite rods (including premium graphite/boron and graphite/titanium blends) had emerged as the materials used by most fly rod manufacturers. These premium rods offer a stiffness, sensitivity, and feel unmatched by any other synthetic material. Graphite composites are especially well-suited to the construction of multi-piece rods since the joints, known as ferrules, in better-quality graphite rods do not significantly affect overall flex or rod action. Today's modern carbon graphite composite fly rods are available in a wide range of sizes and types, from ultralight trout rods to bass fishing rods and two-handed "spey" rods.
References
Johnson, Paul, Sage Manufacturing News Release of 16-weight 1680-4 Xi2 Saltwater Fly Rod, 24 August 2005
|
|
|
|
